MX73 Front Tension Rods

We've designed these front tension rods with simplicity in mind, no fancy parts that cost more money to do a simple job, just tough and functional. The Cressida factory design has some good qualities if you can keep them to your advantage. Made from cold forged 3/4" steel with a tig welded control arm mounting point, we've managed to pack a lot of features into one of the simplest designs to date. With the front section fully threaded all the Caster adjustment is done up front with just two nuts, this has allowed us to keep the center section slimmer and cleaner so your tires and rims don't tag an adjuster sleeve causing damage and running the risk of jarring things loose. This design has also allowed us to offset the rod section through the middle to gain approximately 3/4" more tire clearance over stock arms and 1" more than center adjust styles at max turn in allowing for more steering angle before the tire hits the tension rod. We've also managed to gain adjustment allowing up to 3.5 degrees more caster. Something else people are not usually concerned with but is good to keep in mind, since drifting doesn't always go as planned, these arms are fixable. With the simple design and lack of exotic parts, you can straighten, re-weld and re-use these if they get damaged. Features Bolts directly to stock control arms and front bushings Increases max capicity of steering Sold in pairs, with all required hardware.